Formatting The Sd Card; Exiting The Setup Menu - Tasco 119215C Manuel D'instructions

CAMERA SETuP (continued)
(Only) if you selected "00" for the minutes setting, the last two digits
will blink ,and you can set a delay time in seconds (this is not available
if you selected from "01" to "60" minutes).
• Press "UP" or "DOWN" to change the value (Range from 05-59
seconds), press "OK" to confirm.
Next (last item in the Setup menu), you will see the SD card icon (#7) blink.
You can now check the number of files on your SD card, and format it if
desired.
4. Checking the # of Stored Photo/Video Files
• While the SD Card icon (
stored on the SD card will be seen on the 4 digit Display (#3). This
allows you to confirm if this is a new card or one you have used
previously (and may wish to format).
• Press OK-this will take you to the "Format Card" menu item next.

5. Formatting the SD Card

• With the SD Card icon (#7) blinking (after pressing OK at the end of
the previous Setup step), press "UP" or "DOWN" to select "FO" (Yes,
Format) or "NO" (Do Not Format) then press "OK" to confirm your
choice.
• Press "UP" or "DOWN" to select "Y" (Yes) or "N" (No), then press "OK" to
confirm. This step provides an extra level of safety, to help prevent
you from accidently formatting a card with files you wanted to keep.
If you select "FO" in the first step, then select "Y" and press "OK",
the camera will format the SD card-all files on the card will be
erased.

Exiting the Setup Menu

Once you have finished using the Setup menu, press "SETUP" to save all
your settings, and exit the Setup menu. You are now ready to take your
Trail Cam outside and begin using it to record wildlife activity.
12
#7) is blinking, the total number of files