Clearing Memory; Specification; General Specifications - Amprobe TMA-20HW Mode D'emploi

1.800.561.8187
If change to another Flow Set Up setting, the TEST ID will automatically
increment.
• Push "READ" key to enter READ mode, the display will show " R "
symbol and the memory address number. Push "" or "" key to select
the desired memory address number data for display.
• Push "MX/MN" key to circulated the memory of the maximum (MAX)
air velocity and air flow reading and the memory address number, the
minimum (MIN) air velocity and air flow reading and the memory address
number, and the average (AVG) air velocity and air flow reading and the
total average samples.
• Push "READ" key again to exit the READ mode.

Clearing Memory

• Push key to turn off the meter.
• Push and hold down the "AUTO MEM" key then push
the meter to enter clear memory mode, "CLr no" symbol is displayed.
• Push "Test ID" key to select the desired "TEST ID" to be clear.
• Push "" key to select " " symbol is displayed.
• Push "AUTO MEM" key to clear the memorized data.
• Push "↵" key to exit the clear memory mode.
SPECIFICATIONS

General Specifications

Display :
Velocity Probe :
Duct Size :
Volumetric Flow Rate :
www.
key to turn on
Triple display, 4 digit LCD reading.
Range : 0.1 to 30 m/s (10 to 6000 ft/min)
Resolution : 0.01 m/s (1 ft/min)
Accuracy : ±3% of reading ±1% FS
Range : 1 to 635 cm in increments of 0.1
cm.
(1 to 250 inches in increments of 0.1 in.)
Ranges : Actual range is a function of
actual velocity, and dust size.
8
information@itm.com
.com