Operation; Maintenance - Greenlee H4660B Manuel D'instructions

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Operation

Keep away from the pump outlet/discharge hose
during operation. Liquid and debris will be thrown by
the pump.
Failure to observe this warning could result in severe
injury or death.
Do not change accessories, inspect, adjust, or
clean tool when it is connected to a power source.
Accidental startup can result in serious injury.
Wear eye protection when operating
or servicing this tool.
Failure to wear eye protection could
result in serious eye injury from
flying debris or hydraulic oil.
Skin injection hazard:
• Do not use hands to check for
leaks.
• Do not hold hose or couplers
while the hydraulic system is
pressurized.
• Depressurize the hydraulic system
before servicing.
Oil under pressure easily punc-
tures skin, causing serious injury,
gangrene, or death. If you are
injured by escaping oil, seek medical
attention immediately.
Greenlee / A Textron Company
H4660B Submersible Pump
1. Connect the discharge hose to the discharge port.
2. Start the hydraulic power source.
Note: Allow the power source to run for a few
minutes to warm the hydraulic fluid.
Do not use the hydraulic hoses to lower or lift the
pump. This will weaken or damage the hoses or
fittings, and could cause a hydraulic fluid leak.
Failure to observe this precaution may result in
property damage.
3. Attach a rope or other device to the handle of the
pump. Lower the pump into the material to be
pumped.
4. Actuate the control valve of the power source to
start the flow of hydraulic fluid.
5. When finished pumping, actuate the control valve to
stop the flow of hydraulic fluid.

Maintenance

Use this maintenance schedule to maximize the tool's
service life.
Note: Keep all decals clean and legible, and replace
when necessary.
Daily
1. Wipe all tool surfaces clean.
2. Inspect the hydraulic hoses and fittings for signs
of leaks, cracks, wear, or damage. Replace if
necessary.
3. Install dust caps over the hydraulic ports when the
tool is disconnected.
Monthly
Perform a thorough inspection of the hydraulic hoses
and fittings as described in publication 99930323,
SAE J1273 (Hose and Hose Assemblies).
8
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070

Publicité

Table des Matières
loading

Table des Matières