BE GX390 Mode D'emploi page 9

Starting the Water Pump
Use the following start instructions:
Must ensure pump is primed, and suction hose is in water
source before turning on engine. (see page 14 for instructions)
1. Fill Engine with Oil, SAE 10W30
2. Make sure unit is on a flat, level surface and pump chamber is primed.
3. Turn fuel valve (1) to "On" position. The fuel valve handle will be verti-
cal (pointing toward the ground).
1
4. Push on/off switch (2) to "On" position.
5. Move engine speed lever (3) to "Fast" ( ) position.
3
6. Move choke lever (4) to "On" position.
4
7. Grasp recoil handle and pull slowly until slight resistance is felt. Then
pull handle rapidly to overcome compression, prevent kickback and
start engine.
WARNING
Starter cord kickback (rapid retraction) can result in
bodily injury. Kickback will pull hand and arm toward
engine faster than you can let go.
Broken bones, fractures, bruises, or sprains could
result.
•
When starting engine, pull cord slowly until resistance is felt and
then pull rapidly to avoid kickback.
16
STARTING THE WATER PUMP
2
WWW.BEPOWEREQUIPMENT.COM
STARTING THE WATER PUMP
IMPORTANT: If excessive fuel is present in the air/fuel mixture causing a
"flooded" condition, move choke lever to "Run" position and pull handle
repeatedly until engine starts.
8. Move choke lever to "Run" position a short distance at a time over
several seconds in warm weather or minutes in cold weather. Let
engine run smoothly before each change. Operate with choke in "Run"
position.
IMPORTANT: It may take a few minutes for water pump to begin
pumping water.
WARNING
Contact with muffler area can result in serious burns.
Exhaust heat/gases can ignite combustibles, structures
or damage fuel tank causing a fire.
•
DO NOT touch hot parts and AVOID hot exhaust gases.
•
Allow equipment to cool before touching.
•
Keep at least 5 feet (1.5 m) of clearance on all sides of pressure
washer including overhead.
It is recommended to have the engine on full RPM during operation.
WWW.BEPOWEREQUIPMENT.COM
17