Publicité
All manuals and user guides at all-guides.com
4.
Connect the 3-pin standby power cable from the 24-pin
power adapter to CN1 of the internal receiver. This connector is
shaped so that it only fits one direction.
5.
Connect the wires from CN2 to the power switch (usually
labeled PWR SW) connector on the motherboard. You may
need to refer to the motherboard manual to determine the
correct location. Polarity (positive and negative) does not
matter for switches.
6.
Connect the cable from the PC power switch (usually
labeled POWER SW) to CN3 of the internal receiver.
2
Publicité
