Parts & Assembly - Nostalgia SHAVE ICE ESHVICE2HSI Manuel D'instructions

PARTS & ASSEMBLY
PARTS
Shaver Bowl
(inside)
Two Ice Molds
ASSEMBLY
The ELECTRIC SHAVE ICE MAKER has a sharp stainless steel blade that can cut and
cause injury. Use EXTREME CAUTION when handling the appliance. Keep
fingers clear from blade and avoid contact at all times when using and cleaning.
Wipe the Motor Cabinet with a damp, non-abrasive cloth. Dry thoroughly.
Clean the Shaver Bowl and Base with a soft cloth in warm water
mixed with a mild detergent. Dry with a non-abrasive towel.
• Attach Cone Holder to Base by aligning notches on the Cone Holder with
holes on the Base. Press down on back of Cone Holder to secure.
• Place the Shaver Bowl on top of the Base. Be sure to align arrow
and notch on Shaver Bowl with front of Base.
• With the power cord facing towards the back of the unit,
place Motor Cabinet into Shaver Bowl.
Now you are ready to enjoy cool, refreshing icy drinks from your ELECTRIC SHAVE ICE MAKER!
5
Power Push
Button
Reusable Snow
Cone/Snow
Cone Holder