Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
b) Stopwatch function
• Press the ST/STP (3) key to start the stopwatch.
• Press the ST/STP (3) key to stop the stopwatch.
• With the ST/STP (3) key, the stopwatch can be restarted.
• Press the RESET (1) key after you have stopped the stopwatch to reset the stop-
watch to "0:00:00".
• While the stopwatch is running you can display a split time by pressing the RESET
(1) key. The display indicates the split time but the stopwatch continues to run in the
background.
• Press the RESET key (1) again to return to the stopwatch display.
c) Countdown Timer
Setting the time target
• Press the RESET key (1).
• Use the ST/STP key (3) to set the hour target.
• Press the MODE key (2) to switch to the next setting step (minutes).
• Use the ST/STP key (3) to set the minute target.
• Press the MODE key (2) to switch to the next setting step (seconds).
• Use the ST/STP key (3) to set the second target.
• Press the RESET key (1) to save the time target.
Use of the countdown timer
• Press the ST/STP (3) key to start the countdown timer.
• Press the ST/STP (3) key again to interrupt the countdown timer or to restart it.
• When the preset time has passed, an acoustic signal is emitted for approx. 60 sec-
onds.
• Press any key to turn the acoustic signal off.
d) Alarm function
Activate or deactivate the alarm function
• Press the LIGHT (4) key to select the desired function (hour signal or alarm 1-5).
• To activate or deactivate the hour signal or the selected alarm, press the ST/STP
(3) key. With activated hour signal, a bell icon appears on the right bottom of the
display. With activated alarm, an alarm symbol appears.
• At the set alarm time an alarm sound is emitted for approx. 60 seconds. Press any
key to turn the alarm sound off.
Alarm time setting
• Select the alarm function to be set (alarm 1-5) using the LIGHT (4) key.
• Press the RESET key (1) to select the hour display.
• Use the ST/STP key (3) to set the hour display.
• Press the MODE key (2) to select minute display.
• Use the ST/STP key (3) to set the minute display.
• Press the RESET key (1) to save the setting.
e) Time of the second time zone
• Press the RESET key (1) to select the hour display.
• Use the ST/STP key (3) to set the hour display.
• Press the MODE key (2) to select minute display.
• Use the ST/STP key (3) to set the minute display. The minute display is changed in
30-minute steps.
• Press the RESET key (1) to save the setting.
f) Pacer function
• Press the RESET (1) key to set the number of acoustic signals per minute (10, 20, 30,
40, 60, 80, 120, 160, 240 or 320).
• Press the ST/STP (3) key to start the pacer function.
• Press the ST/STP (3) key to stop the pacer function again.
Illumination
• Press the LIGHT key (4) to turn on the clock face light for a few seconds.
Battery Notes
• Batteries should be kept out of the reach of children.
• Do not leave batteries lying around in the open; there is a risk of them being swal-
lowed by children or pets. If they are swallowed, consult a doctor immediately.
• Leaking or damaged batteries can lead to caustic burning of the skin. Therefore, use
suitable protective gloves.
• Batteries must not be short-circuited, opened or thrown into a fire. There is a risk of
explosion!
• Do not recharge normal, non-rechargeable batteries, due to risk of explosion! Only
charge rechargeable batteries that are intended for this purpose; use a suitable
battery charger.
• Please pay attention to the correct polarity (plus/+ and minus/-) when inserting the
battery.
Changing the Batteries
• If the display does not show anything, the battery has to be replaced.
• Replacing the battery should be done by a specialist, using special clockmaker tools
and professional knowledge.
• To replace the battery, the bottom of the casing is removed.
• The battery can then be removed from its holder and be replaced.
Water and Shock Resistance
In normal use, the wristwatch is protected against shocks. Nevertheless, do not ex-
pose the device to extreme shocks such as it might occur if the device falls onto a hard
surface. This might damage the watch mechanism.
The labelling 10 ATM means that the watch is suitable for bathing, swimming, car
wash, showering and so on.
It is not a diver's watch. Never press the buttons under water.
Maintenance and cleaning
To clean the watch, a dry, soft and clean cloth is sufficient. For heavier soiling of the
exterior, you can moisten the cloth slightly with lukewarm water.
Clean the watch very carefully; otherwise you may scratch it.
Do not press too heavily on the glass cover, as this can lead to breakage
Disposal
a) Product
Electronic devices are recyclable waste materials and must not be disposed
of in the household waste!
Dispose of an unserviceable product in accordance with the relevant statu-
tory regulations.
Remove the battery if there is one inserted and dispose of it separately from
the product.
b) Normal and Rechargeable Batteries
As the end user, you are required by law (Battery Regulation) to return used batteries
and rechargeable batteries. Do not dispose of used batteries in the household waste!
Batteries/rechargeable batteries contain harmful materials and are labelled
with the symbol shown to indicate that disposal in the household waste
is forbidden. The symbols of the relevant heavy metals are: Cd=cadmium,
Hg=mercury, Pb=lead (marking can be seen on the battery/rechargeable
battery, e.g. underneath the refuse bin symbol shown on the left).
You can return your used batteries/rechargeable batteries free of charge at the official
collection points of your community, in our stores, or at places where batteries or
rechargeable batteries are sold!
You thereby fulfil your statutory obligations and contribute to the protection of the
environment.
Technical data
Operating voltage............................... 3 V/DC
Battery 1 x lithium coin cell ............. CR2025
Battery life ......................................... approx. 2 years
Water-tightness .................................. 10 ATM
Weight .................................................. 65 g
These operating instructions are a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microfilming, or the capture in electronic data
processing systems require the prior written approval by the editor. Reprinting, also in part, is prohibited.
These operating instructions represent the technical status at the time of printing. Changes in technology and equipment reserved.
© Copyright 2013 by Conrad Electronic SE.
Publicité
Table des Matières
