Southland SRTT212 Manuel De L'opérateur page 14

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Operation
(Continued)
• Save all instructions
H
Adjustments
WARNING
Engine should be off before adjusting any controls .
Extreme caution should be used when operating tiller in the
reverse direction .
Wheel Lock Pins
(See Figures 2 on pg . 8 and 11)
Place wheels in tilling position.
1 . Remove lock pin . Align hole in axle with hole in wheel hub .
2 . Insert lock pin through holes, fold lock pin ring to secure
pin to axle .
3 . Firmly lock wheel and axle together before tilling .
4 . Repeat for other wheel .
WARNING
Always have both wheel lock pins in or out . Do not operate
tiller with only one wheel locked .
To place wheels in free-wheel position.
1 . Remove lock pin . Slide wheel inward toward machine .
2 . Insert pin in axle only, fold lock pin ring to secure pin to axle .
3 . Wheel should turn freely on axle .
Handlebar Height Adjustment
Adjust handlebar height.
The ideal height of the handlebar varies with operator
height and the depth of tilling . To adjust handlebar
height:
1 . Unscrew nuts and remove top bolts on each side .
2 . Loosen the lower bolts . Do not remove .
3 . Align handlebar to desired holes on the lower
handlebar mount .
4 . Install bolts and nuts . Retighten all four bolts securely .
Depth Regulator
(See Figure 3 on pg . 8)
Tilling depth is controlled by the height of the
depth regulator. To adjust tilling depth:
1 . Remove pin .
2 . Raise the depth regulator to position tines at chosen
tilling depth .
3 . Align hole in depth regulator with hole in depth regulator
bracket and replace pin .
Depth Regulator Down = Shallower tilling .
Place the pin in the top hole of the depth regulator for
shallowest tilling .
Depth Regulator Up = Deeper tilling .
Place the pin in the bottom hole of the depth regulator for
deepest tilling .
Questions? Call Toll Free at 1-800-737-2112
(See Figure 4 on pg . 9)
WARNING
Do not adjust tilling depth unless drive safety control levers are
released to neutral position .
Always set the depth regulator in the transport position
before starting engine, that is, place the detent pin in the
highest hole of the depth regulator .
Wheel lock pin in free-wheel position
(axle holes only)
Copyright © 2018 MAT Engine Technologies, LLC
13
FRONT
Figure 11

Publicité

Table des Matières
loading

Table des Matières