Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Setup
1
for Non-amplified Rayzar
™
If setting up a non-amplified
Rayzar antenna, connect
the mini coaxial (coax)
cable to the "Antenna
In" coax port on the TV
or compatible device.
Continue with step 2.
for Amplified Rayzar Antennas*
If setting up the Rayzar Amped
antenna, connect the mini coax
cable to the "Antenna In" port
as shown above. Plug the mini
USB into the "USB PWR" port
of the amplifier. Then, plug
the regular USB into the USB
port of the TV, 12V adaptor, or
110V adaptor. If plugging the
USB into the 12V adaptor, then
plug the 12V adaptor into a 12V
outlet. If plugging the USB into
the 110V adaptor, then plug the
110V adaptor into a 110V outlet.
2
Position the antenna toward the broadcast tower for optimal
reception. For a listing of likely channels available in your area, go
online to dtv.gov/maps.
3
Run a channel scan. To keep your channel line-up up-to-date, it is a
good idea to run a channel scan monthly.
4
The antenna may need to be repositioned. If so, run a channel scan
every time you reposition the antenna.
WARNING: While the Rayzar antenna has been designed with quality
and durability in mind, the antenna is not weatherproof and should
not be installed outside in rain, snow, excessive wind, etc.
WARNING: Do not paint the antenna. This could block signal and void
your warranty.
*If unsure of your antenna type, refer to the "Specifications" section of this document.
Antennas*
Mounting the Antenna
Once the best location for the antenna has been determined, secure
the antenna with the suction cup clips. For stability, secure the clips
to opposite corners of the antenna, but slightly offset the clips from
the corners. Mount the antenna in the desired location.
+
TIP: Avoid mounting the antenna on metal objects; such objects could
obstruct signal.
If more coaxial cable is needed to mount the antenna in the desired
location, connect the mini coax cable to a female-to-female barrel
connector (Winegard model FS-8100, sold separately), and attach
additional coaxial cable.
Questions & Answers
Q
How do I run a channel scan?
Using the television remote, select "Menu." Then, select "Channel
A
Setup." Select "Antenna" or "Off-Air Mode" or "Auto-scan,"
depending on your TV. Select "Channel Search" or "Channel Scan."
Keep in mind that steps to perform a channel scan may vary. If the
wording in your TV differs from the options shown, refer to your TV
user manual for help.
Tip
Running a channel scan is NOT the same as pressing Channel
UP/DOWN on your remote.
When do I need to run a channel scan?
Q
To receive maximum programming, you have to run a channel scan
A
after setting up the antenna. To keep your channel line-up up-to-date,
it is a good idea to run a channel scan monthly and anytime a channel
is lost.
Publicité
Table des Matières
