Installation Instructions - Superwinch 06302 Manuel Du Propriétaire

INSTALLATION INSTRUCTIONS

Do not attempt to install wiring when the battery is
DANGER
!
connected. Automotive batteries contain flammable
and explosive gases. Wear eye protection during installation and
remove all metal jewelry. Do not lean over battery while making
connections.
Check to ensure that the vehicle ground and positive leads from the
battery are disconnected before performing any electrical work.
Step 1
Disconnect the battery before beginning installation.
Step 2
Locate a place to mount the Wireless Control unit. Under dash, console,
or inside wall of a box trailer would be typical locations. The unit can be
mounted in any orientation, inside or outside the vehicle or trailer. The
unit is mounted with 4 self-tapping screws (provided in hardware kit) or
with 4 # 8 bolts and nuts (Not provided).
See Figure 2 and 3.
Be sure to keep components away from moving
CAUTION
!
parts, sharp objects, or hot areas of the machine.
When using self-tapping screws, ensure that there
CAUTION
!
are no components, wires, or parts that can be
damaged by the screws.
Locate a place to mount the antenna. Mount the antenna a minimum of
2 feet away from the winch motor and high current motor leads to avoid
motor noise interference. The antenna mounts with cable ties or screws.
See Figure 1. Connect the antenna wire connector to back of the Wireless
Control unit. See Figure 2.
Mounting
Holes
3
Figure 1
Control
Unit
Winch
Harness
Connection
FOR P/N 06702
Plug in winch wiring cable to back of control unit connector. See Figure 2.
Connect the winch end plug to the winch socket by aligning the white
mark on the plug housing with the white mark on the winch socket.
FOR P/N 06302
Plug in winch wiring cable to back of control unit connector. The
separate black ground wire MUST be connected to vehicle or trailer
ground. See Figure 3.
If control unit is not mounted to a grounded surface, run harness ground
wire to suitable vehicle ground. Connect the winch end plug to the winch
socket by aligning the keyway on the plug housing with the keyway on the
winch socket.
Vehicle
Ground
Mounting
Screws
Antenna
Connection
Figure 2
Ground Wire
(06302 only)
Figure 3
4