RCF TTS56-A Mode D'emploi page 10

rDNet CONNECTION
The system is equipped with an RDNet connection on board.
Using an RDNet controller unit it is possible to:
- receive status information from the system (amplifiers status, signal levels, system
settings,...).
-
Send commands to the system (mute, solo, change sensitivity, change setting, set user
eq, ...).
- See the RDNet user manual for details.
rDNet BY-PASS SWITCH
When the RDNet is present and the RDNet LINK LED is green the controller takes control
over the module independently of the BY-PASS SWITCH position.
When the rDNet is not present, the BY-PASS switch act as follow:
- BY-PASS SWITCH pressed (LED ON): the system bypass the input board and reads
the RDNet user settings (last configuration saved).
- BY-PASS SWITCH released (LED OFF): the system reads the input board and bypass
the user setting eventually loaded ion the speaker (last configuration eventually saved).
TTS56-A DEfAULT CONfIGUrATION
The TTS56-A factory default configuration (the configuration that the system reads if
the BY-PASS switch is pressed) is the following:
Sensitivity +4 dBu
High pass 30 Hz
Low pass 90 Hz
Cardioid OFF
Delay 0
Bypass OFF
User filters ALL FLAT
If the user set with RDNet a new configuration, the new configuration will be recalled
when the BY-PASS switch is pressed.
BY-PASS SWITCH rDNet
ON ON
OFF ON
ON OFF
OFF OFF
10
BY-PASS LED fUNCTION
ON Reads RDNet settings
OFF Reads RDNet settings
ON Reads last saved used configuration
OFF Reads input panel
rDNet
rDNet CONNECTION
rDNet BY-PASS SWITCH
TTS56-A
DEfAULT CONfIGUrATION