Swingline GBC FUSION 1000L Manuel D'utilisation page 6

English
getting ready to laminate
Easy Set Up
1 Remove the plastic exit tray from the box and place into the two holes on the back of the
laminator and extend to use. Ensure that there is sufficient space behind the laminator for
the item to be removed.
2 Take the electrical plug and place in an appropriate power source, which is near the table
you intend to use.
The laminator will briefly flash the Swingline GBC logo on the control panel and will make
3
an audible beep.
Interactive User Display
4 To use the laminator gently tap the 'power on' button. A sequence of lights will cross the
control panel.
NOTE: Your new laminator may emit
a slight odor during the initial
operation. Its is normal and will
diminish after a few hours of
operation.
5 If 3 mil is not the pouch thickness you want to select, using the arrows scroll until the required
pouch thickness setting is shown and press "Enter".
Intelligent Pouch Select
6 Using the 'Auto' setting allows the user to use any thickness of pouch and the laminator
will automatically measure the thickness of the pouch and document and self set to the
appropriate speed.
NOTE: During warm up a circle will be
formed on the control panel and a
red indicator will flash in the centre
of the circle until ready (
When ready a series of three beeps
are heard and the (
on the display. The machine will not
take any pouch during warm up.
6
register this product online at www.swingline.com
).
) will show