HTC HTT-31 Manuel De L'utilisateur page 4

!
All attachments, besides the table top, are done with
the following hardware: Machine Screw
a washer , and a Nut
1
Insert rubber feet
Notice: the correct end has two rectangular holes.
An adjustment nut/bolt goes through the center of
the foot and can adjust the stand on uneven floors
2
Attach the Long Center Frame
Support to the legs
Repeat again with remaining
parts and
3
Attach the two Short Center
Frame Supports
assembled sides from Step 2.
4
Attach the remaining assembled side from
Step 2 to the parts assembled in Step 3
.
onto ends of legs
.
.
to one of the
,
.
4