Sensor Test; Panel Test; Chime Setup - 2GIG e Serie Mode D'emploi

GC2e Wireless Security System | User Guide

Sensor Test

When each sensor is tested, the Control Panel does the
following:
● Beep sand announces the sensor's name
● Displays green bar lights by the sensor name
● Displays green signal bars to show the strength of that
sensor's wireless signal.
NOTE: Start and stop test reports are sent to the Central
Station.
1 At the System Test: Console screen, a list of sensors
appears. Use the  and  arrows to scroll through the
list.
2 Go to each sensor listed, and trigger it.
● For door or window sensors, open and close the
door or window.
● For motion detectors, stay out of the protected area
for five (5) minutes, then walk through the area.
● For portable sensors and wireless keypads, tap a
button.
● For smoke, CO, or glass break detectors, tap the
detector's test button.
TIP: When a red bar is displayed for a sensor, the test has
failed our recommended sensitivity or range test.
3 When all sensors have been tested, tap OK. Then
continue with the Panel Test.

Panel Test

The panel test checks the Control Panel's indicators and
sounder.
1 At the System Test: Console screen, a list of tests
to perform on the panel appears. Use the  and 
arrows to scroll through the list.
2 Tap each button in the list. Then tap Yes or No to
respond to the test question.
3 After answering all of the questions, tap OK.
4 At the System Test Successful screen, tap OK.

CHIME SETUP

On doors and windows monitored by sensors, the system
can sound a chime to announce that the door or window
was opened. Sensors can also be set to have the Control
Panel say the name of the opening.
TIP: The chime and voice announcements only sound
while the system is disarmed.
At the time of installation, the installer programs each
sensor's chime option. The person with the master
user code can change the chime options for each sensor to
further customize the system as desired.
TIP: As a global system option, the chimes for all the
system's sensors can be turned on or off using the Chime
check box on the Menu screen.
30
System Toolbox
Copyright © 2019 Nortek Security & Control