IML BIG DISCOVERY Serie Manuel D'installation Et D'entretien page 34

START-UP
•
Open all valves and connect the motor.
•
Wait a suitable time for tubing auto-priming to take place.
5. MAINTENANCE
•
Clean the pre-filter basket regularly in order to avoid drops in pressure. In order to avoid
possible basket breakage it is recommended not to knock it during the cleaning process.
•
If the pump stops, check that the motor amp consumption during his working is the same
or less than that indicated on the manufacturer's specification board, or failing him,
contact the nearest Customer Technical Service.
•
If the amp rate is higher, consult the manufacturer.
•
Empty the pump in cases where it must remain without use for some time, mainly in cold
countries where there may be danger of freezing.
•
To empty the pump, remove the draining plug from the pump body (see explosion
drawing).
•
Each time the pre-filter is opened, clean impurities from the joint seating and the joint
itself, to ensure sealing on closure of the cover (Fig.4).
6. DISMANTLING
•
The motor unit may be dismantled from the pump body without needing to disconnect the
pump's suction and impulsion tubing.
•
To disconnect the motor unit from the pump body, remove the screws that join them (see
explosion drawing).
CORRECTO-CORRECT-CORRECT
Fig.5
34
INCORRECTO-INCORRECT-INCORRECT