PEHA AudioPoint Notice D'installation Et D'utilisation page 50

Assembly and installation
5.2 Step 2
The display unit is hardwired to the lower section!
The display unit is installed after mounting the lower section.
1
2
• Attach the supply line to terminal L, N on the back of the display unit (3).
If desired an extension (button, switch or motion detector) can be attached to terminal 1.
• Snap the display unit into the lower section (2). If the wiring harness is too long it can be
pushed into the speaker housing (1).
• To disassemble the display unit, snap out the display unit by pressing lightly and take out.
Alternative component set! For production reasons, the AudioPoint may contain different types of aerial. When
using the aerial on the pc-board in the base of the enclosure the plug of the aerial cable is to be connected to the
socket in the middle of the unit.
GB - 48
N 1 L
3
Notes:
– During the installation to the mains (230 V/50 Hz~) the
electrical system has to be without voltage.
N
– Secure the power line (230 V~/50 Hz) with a
F
circuit breaker (max. 16 A).
L
– Please note! Ensure phase balance of the extension!
230V~/50Hz
GB