Maintenance And Service - Enerpac XLP Serie Fiche D'instructions

WARNING: When operating the press, always make
sure the support pins are in their proper location.
Failure to insert these pins properly during usage
will result in equipment damage and possible
personal injury. The Bolster must rest completely on the support
pins, and all tension removed from the winch cable before
operating cylinder.
4.1 Hand Pumps
Close release valve, then raise and lower the pump handle to
advance the cylinder to the desired stroke. To retract the cylinder,
open the release valve.
4.2 Air Powered Pumps
Depress the pressure side of the treadle to activate the throttle
and advance the cylinder to desired stroke. To retract the cylinder
depress release.
4.3 Air Removal
With the pump positioned higher than the cylinder, advance and
retract the cylinder several times avoiding pressure build-up. Air
removal is complete when the cylinder motion is smooth.Carefully
read the instructions included with the pump and cylinder for
detailed procedures of air removal.

5.0 MAINTENANCE AND SERVICE

Regularly inspect all components to detect any problem requiring
maintenance and service.
1. Replace damaged parts immediately
2. Do not exceed oil temperature above (60°C)
3. Keep all hydraulic components clean
4. Periodically check the hydraulic system for loose connections
and leaks
5. Change hydraulic oil in your system as recommended in the
pump instruction sheet
6. Periodically check the press frame to make sure all bolts
are tight and frame parts are undamaged. Immediately
replace worn or damaged parts with genuine Enerpac parts.
Hydraulic equipment must only be serviced by a qualified
hydraulic technician. For repair contact your nearest authorized
Enerpac Service Center.
Press Maximum
Capacity Daylight (mm)
Vertical Horizontal
ton (kN)
1225 510
25 (232)
1225 510
Speed (mm/s) **
Rapid Pressing
Advance
A
{3,4} ** {0,7} ** 260 140 510
10,0 1,3 260 140 610
Press
Model Number
Pump Type
Man. Air
•
-
XLP-256P392
- •
XLP-256XA11G
B C D E F
32 510 630 700 1622 1740 370 140 212 1070 122 165
32 510 630 700 1622 1740 370 323 212 1070 122 170
XLP 25 ton Press
Power Source
Pump Stroke
Valve Type
Model Nr. (mm)
Man.
•
P-392
•
XA-11G
Dimensions (mm)
G H J K M
3
Cylinder
Single-Acting
Cylinder
Model Nr.
158 RC-256
158 RC-256
N O P (kg)
Press
Model Number
XLP-256P392
XLP-256XA11G
GB