Dmx Control - FONESTAR PAR-220L Mode D'emploi

DMX CONTROL

To control the device using a DMX controller:
- Select the desired DMX operation mode: 8 or 4 channels as shown in the table above. Use the MODE and
SET button to select the number of channels and press ENTER to confirm the setting.
- Select the DMX address to control this LED bar with a value between 1 and 512. Use the MODE and SET
button to select the DMX address and press ENTER to confirm the setting.
- Below are the features of each channel in the different DMX operating modes:
4 channels (d):
8 channels (A):
- It is possible to cascade several devices to be managed together (if they are in the same DMX address) or
separately (if they are in different DMX addresses).
Use an XLR cable to connect the device's DMX IN to the DMX OUT of the DMX controller when the device
is the first element in the chain. Alternatively, connect to the DMX OUT of the preceding element in the
lighting chain of your installation.
You can also supply power from one light to the next in the chain in the same way as shown in the picture.
CHANNEL VALUE
CH1 000-255
CH2 000-255
CH3 000-255
CH4 000-255
CHANNEL VALUE
CH1 000-255
CH2 000-255
CH3 000-255
CH4 000-255
CH5 000-255
CH6 000-255
000-050
096-107
108-119
CH7
120-132
133-143
251-255
CH8 000-255
FUNCTION
Red intensity
Green intensity
Blue intensity
White intensity
FUNCTION
Overall light intensity
Red intensity
Green intensity
Blue intensity
White intensity
RGB strobe speed
No effect
Effect 1
Effect 2
Effect 3
Effect 4
Sound activated
Speed, from slow to fast
- 3 -
EN