Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
The fully charged battery has power
for up to 5 hours of talk time or up
to 120 hours of standby time.
To check the battery charge when the
headset is not connected to a charger,
press the multifunction key when the
headset is connected to a cellular
phone. If the indicator light is green,
the charge level is sufficient. If the
light is yellow, you may need to
recharge the battery soon. If the
light is red, recharge the battery.
When the battery charge is low, the
headset beeps every 5 minutes and
the red indicator light flashes.
Switch on or off
To switch on, press and hold the
multifunction key for about 2 seconds.
The headset beeps, and the green
indicator light is displayed. The
headset tries to connect to the last
used device. When the headset is
connected to a device and is ready for
use, the green indicator light flashes
slowly. If the headset has not been
paired with a device, it automatically
enters pairing mode.
To switch off, press and hold the
multifunction key for about 5 seconds.
The headset beeps, and the red
indicator light is briefly displayed.
If the headset is not connected to
a device within about 30 minutes,
it switches off automatically.
Pair and connect the headset
Before using the headset, you must
pair and connect it to a compatible
device.
You can pair the headset with up to
eight devices, but you can connect it
to only one device at a time.
1. Make sure your cellular phone is
switched on and the headset is off.
2. If the headset has not been
previously paired with a device,
ENGLISH
Publicité
Table des Matières
