casmar BOX1-DCS Mode D'emploi page 19

This function enables you to cancel any lost or robbed transmitter,
using the same code and without the necessity of having the
receiver present in order to cancel the lost code. By means of a MANAGER
or MINIMAN portable programmer and knowing the code, you can change
the "Replacement Number", from "0" to "7" (0 is the first remote
control delivered by the factory, and 7 the last "replacement" before setting
the code as obsolete in the installation). The system permits such "replacements"
from a new transmitter, changing the code and "Replacement Number"
(see MANAGER portable programmer manual). Emitting the code to the
receiver, the new replacement number will cancel the previous one and will
be automatically updated.
In the installation, the user must activate the transmitter twice. The first time,
the receiver updates the new element and cancels the previous one. The
second time, the receiver activates the corresponding operation in the
receiver.
USE OF THE MICRORECEIVER
This receiver is designed to operate automatic garage door openers, provide
the movement signals to control boards and connect/disconnect alarms.
No warranty is offered for USE in direct activation of units other than those
specified.
In compliance with the European Directive low-voltage electrical equipment,
we hereby inform users of the following requirements:
˙ For units which are permanently connected, an easily accessible
circuit-breaker device must be built into the wiring system.
˙ This unit must always be installed in a vertical position and firmly fixed
to the structure of the building.
˙ This unit must only be handled by a specialised installer, by his
maintenance staff or by a duly trained operator.
˙ The instruction manual for this unit must always remain in the
possession of the user.
"The CE marking affixed to this device indicates that it complies with the
requirements set forth in the electromagnetic compatibility Directive
89/336/EEC".
CODE REPLACEMENT
IMPORTANT ANNEX
18