Publicité

Liens rapides

Save These Instructions. This manual will help you to obtain
efficient, dependable service from the heater, and enable
you to order repair parts correctly. Keep in a safe place for
If this heater is not properly installed, a house fire may result.
For your safety, follow the installation instructions. Never
use make-shift compromises during the installation of this
heater. Contact local building or fire officials about permits,
restrictions and installation requirements in your area.
Please read this entire manual before you install or use your
new room heater. Failure to follow instructions may result in
property damage, bodily injury, or even death. Improper
Installation Could Void Your Warranty!
ALL PICTURES SHOWN ARE FOR ILLUSTRATIVE PURPOSES
ONLY. ACTUAL PRODUCT MAY VARY DUE TO PRODUCT
This manual is subject to change without notice.
MODEL: AW1820E
future reference.
SAFETY NOTICE:
CAUTION!
ENHANCEMENT.
United States Stove Company
PO Box 151, 227 Industrial Park Rd.,
South Pittsburg, TN 37380
PH: (800) 750-2723
www.usstove.com
Report Number: F19-552
Tested Per EPA Methods ALT-125, ASTM
E2515, ASTM E3053 and CSA B415
Certified to: UL 1482-2011 (R2015), ULC-
628-93
Do not install this heater in a mobile
home or trailer.
U.S. Environmental Protection Agency
Certified to comply with 2020
Ce produit peut vous exposer à des agents chimiques, y compris au monoxyde de
particulate emissions standards.
carbone, lesquels sont reconnus dans l'État de la Californie comme causant le cancer et
des malformations congénitales ou autres dommages au fœtus. Pour obtenir plus de
renseignements, veuillez consulter le site www.P65warnings.ca.gov
CALIFORNIA PROPOSITION 65 WARNING:
This product can expose you to chemicals including carbon monoxide, which
is known to the State of California to cause cancer, birth defects and/or other
reproductive harm. For more information, go to www.P65warnings.ca.gov
R
853668-1004J

Publicité

Table des Matières
loading

Sommaire des Matières pour Ashley AW1820E

  • Page 1 MODEL: AW1820E Save These Instructions. This manual will help you to obtain efficient, dependable service from the heater, and enable you to order repair parts correctly. Keep in a safe place for future reference. SAFETY NOTICE: Report Number: F19-552 If this heater is not properly installed, a house fire may result.
  • Page 2 The instructions pertaining to the installation of your wood stove comply with UL 1482-2011 (R2015) and ULC-628- 93 standards. This manual describes the installation and operation of the Ashley, AW1820E wood heater. This heater meets the 2020 U.S. Environmental Protection Agency’s crib wood emission limits for wood heaters sold after May 15, 2020.
  • Page 3: Dimensions

    doors as needed to clear the smoke and odor. If 24. Permanently seal any opening between the the appliance is overfired, the paint will discolor. masonry of the fireplace and the facing masonry. When installing your unit, take care in handling. 25.
  • Page 4: Pre-Installation Requirements

    Pre-Installation Requirements FIREPLACE CONDITION AND ZERO CLEARANCE REQUIREMENTS A masonry fireplace must meet minimum code requirements, National Fire Protection Association, (NFPA) 211, or the equivalent for a safe installation. Contact a professional, licensed installer, your local building inspector or the local fire authority for the requirements in your area.
  • Page 5 a. Existing fuel-fired equipment shows evidence of back puffing, smoke roll-out, inefficient operation, or excessive smell in the living area. b. Opening a window or door alleviates any of the above problems or symptoms. c. The building is constructed with a well-sealed vapor barrier, tight fitting windows, or has powered exhaust fans.
  • Page 6 Assembly Instructions CAUTION: This appliance is heavy. Make sure that you have adequate help and use proper lifting techniques whenever moving this appliance. 1. Clean fireplace opening properly disposing of any ashes in a closed metal container. See Safety Instructions. 2.
  • Page 7: Blower Installation

    11. Assemble the trim frame. The trim consists of a left (6) and right (5) side piece and a split top piece (left #8, right #7). These are joined by corner connectors (11-13) and two straight center connectors (9-10). These slide into the channel on the back of the frame and are secured with two set screws (13) in each piece.
  • Page 8: Chimney Specifications

    Chimney Specifications This appliance must be connected to a listed Stainless Steel Liner, that meets UL1777, which extends from the collar to the chimney cap according to the specifications listed on the previous pages. Take into account the chimney’s location to ensure it is not too close to neighbors or in a valley which may cause unhealthy or nuisance conditions.
  • Page 9: Fuel Recommendations

    Fuel Recommendations WOODSTOVE UTILIZATION Your heating appliance was designed to burn wood only; no other materials should be burned. Waste and other flammable materials should not be burned in your stove. Any type of wood may be used in your stove, but specific varieties have better energy yields than others.
  • Page 10 Operating Instructions CAUTIONS: HOUSE FIRE HAZARDS • Do not store wood on floor protector, underneath stovepipe(s) if applicable, or anywhere within clearances to combustible surfaces specified for this appliance. • Never operate with secondary tubes, fiber board, or insulation removed. OPERATING SAFETY PRECAUTIONS •...
  • Page 11: Fueling Instructions

    Do not burn manufactured logs made of wax impregnated sawdust or logs with any chemical additives. Manufactured logs made of 100% compressed sawdust can be burned, but be careful burning too much of these logs at the same time. Start with one manufactured log and see how the stove reacts.
  • Page 12: Adding Fuel

    Rotate the air control fully down. Light the newspaper and close the door. Once the kindling has burned down to a starter coal bed, load the unit with approximately 12 to 13 lbs of fuel for the first high burn load. HIGH 12 to 13 lbs After the first high burn load and the stove is well warmed up, adjust the unit as needed for a medium or low burn...
  • Page 13: Chimney Maintenance

    8. Burn small, intense fires instead of large, slow burning fires when possible. Large slow burning fires can deposit creosote within the heating system. 9. Learn your appliance’s operating characteristics to obtain optimum performance. VISIBLE SMOKE The amount of visible smoke being produced can be an effective method of determining how efficiently the combustion process is taking place at the given settings.
  • Page 14: Chimney Draft

    CHIMNEY DRAFT NOTE: A DRAFT READING OF 0.05[12.45] to 0.06[14.94] (Water Column[Pascals]) IS REQUIRED FOR PROPER BURNING OF THIS APPLIANCE. Draft is a function of the chimney, NOT THE APPLIANCE — Do not expect the appliance to draw. Smoke spillage into the house or excess buildup of condensation or creosote in the chimney are warnings that the chimney is NOT functioning properly.
  • Page 15: Glass Replacement

    GLASS REPLACEMENT 1. Ensure appliance is not in operation and is thoroughly cooled. 2. Remove screw and glass clip. (See parts list and diagram.) 3. Lift glass out from glass clip. 4. Remove old gasket and clean glass. 5. Replace new gasket starting at the bottom of glass working along edges, being sure to center gasket channel on glass.
  • Page 16: Wiring Diagram

    Wiring Diagram -16-...
  • Page 17: Repair Parts

    Repair Parts Part # Description Part # Description 892176 Top Trim 892294 Hinge Pin 892177 Hearth Plate Trim 40571 Hinge Block 80857 Assembly, Blower 83913 Extension Spring 611008 Right Cabinet 26269 Top Surround 893261 Damper Slide 26270 Side Surround 29301 Slide Brace 891992-1 Surround Trim-R 893261...
  • Page 18 Repair Parts Part # Description 891167 Spring Handle 893071 Door Handle 83788 Socket Head Screw 83242 1/4-20 X 1/4 Allen Set Screw 893062 Roller Sleeve 40883 Medium Arched Door 88324 1” Rope Gasket 5 ft 893159 Clear Glass 29229 Side Glass Retainer 29227 Top Glass Retainer 29230...
  • Page 19 Notes -19-...
  • Page 20: Service Provider

    Service Record It is recommended that your heating system is serviced regularly and that the appropriate Service Interval Record is completed. SERVICE PROVIDER Before completing the appropriate Service Record below, please ensure you have carried out the service as described in the manufacturer’s instructions. Always use the manufacturer's specified spare part when replacement is necessary.
  • Page 21 How To Order Repair Parts / Comment Commander Les Pièces De Rechange This manual will help you obtain efficient, dependable service from your heater, and enable you to order repair parts correctly. Keep this manual in a safe place for future reference. When writing, always give the full model number which is on the nameplate attached to the heater.
  • Page 25 Noire Blanche...

Table des Matières