Viking VINV600 Mode D'emploi page 2

Model VINV600 Ventilator Kit
VENTILATOR KIT INSTALLATION
1. Attach the GUARD with (3) M4 x 0.7 screws provided.
2. Choose the correct VENTILATOR MOUNTING PLATE for your hood series.
(VBCV53638 and VBCV54238 will only be shipped with the 050722-000 mounting
plate.)
3. Attach DAMPER to ventilator mounting plate, as shown. Use three (3) HEX
SCREWS. Note: Damper FLANGE to be captured by screw heads.
4. Apply (4) NEOPRENE WASHERS (supplied) to each of the mounting plate STUDS.
5. Attach BLOWER to MOUNTING PLATE with (4) 10-24 HEX NUTS.
6. Attach blower / mounting plate assembly to the hood's (4) THREADED STUDS with
(4) 10-24 HEX NUTS.
7. Plug blower's POWER CORD into RECEPTACLE inside the hood.
8. Wrap wires with wire tie (provided).
Ventilator configuration using
mounting plate 020970-000
THREADED
TOP OF HOOD
STUDS
DAMPER
RECEPTACLE
MOUNTING
STUDS
BLOWER
POWER
CORD
Ventilator configuration using
mounting plate 020971-000
THREADED
STUDS
DAMPER
HEX
SCREWS
FLANGE
RECEPTACLE
PLATE
NEOPRENE
WASHERS
POWER
HEX NUTS
CORD
TOP OF HOOD
HEX
SCREWS
FLANGE
MOUNTING
PLATE
STUDS
NEOPRENE
WASHERS
BLOWER
HEX NUTS
2
GUARD
Ventilator configuration using
mounting plate 020972-000 or
050722-000
THREADED TOP OF HOOD
STUDS
DAMPER
RECEPTACLE
MOUNTING
STUDS
BLOWER
POWER
CORD
HEX
SCREWS
FLANGE
PLATE
NEOPRENE
WASHERS
HEX
NUTS