Changing The Battery; Connection; Operation; Place The Battery In The Remote Control - Goobay 58690 Mode D'emploi

5.2

Changing the battery

Battery type:
1� Replace the empty battery with a new one of the same type if necessary�
The battery compartment is located on the back of the remote control.
The direction of insertion is marked on the product.
2� Dispose of the empty battery properly�
Please also read the chapter Disposal instructions.
6

Connection

CAUTION!
• Do not plug in one behind the other�
• Never operate irons, radiant heaters and similar appliances that pose a fire
hazard via the radio-controlled socket�
1� Plug the radio-controlled socket into an easily accessible earthed socket�
2� Connect 1 appliance with a maximum of 1100 W to the radio-controlled so-
cket�
7

Operation

7.1

Place the battery in the remote control

1� Open the battery cover (4) of the transmitter�
2� Insert a CR2032 3V battery�
3� Press a button on the remote control to check whether it can work�
The LED lights up to indicate that the remote control is working.
7.2

Pairing with the remote control

1� Plug the radio-controlled socket into an earthed socket�
The LED now starts to flash slowly. The radio-controlled socket is in teach-
in mode. If no action is taken, the teach-in mode is exited again after 29
seconds. In this case, the radio-controlled socket must be disconnec-
ted again and reconnected to the earthed socket in order to reactivate the
teach-in mode.
2� Press channel 1 ON, 2 ON or 3 ON of the transmitter to pair it with the ra-
dio-controlled socket�
After successful pairing, the LED indicator of the radio-controlled socket
stops flashing slowly and starts to light up.
3� Now you can switch the radio-controlled socket on and off by pressing ON
or OFF of the respective channel on the remote control�
If the LED indicator of the radio-controlled socket lights up, the power is
on. If it is not lit, the power is off.
7.3

Delete selected channel

1� Pull out the radio-controlled socket and insert it into the socket (the LED in-
dicator flashes slowly in teach-in mode).
2� then press the OFF button of the selected channel�
The LED display of the radio-controlled socket flashes quickly (3-4 se-
conds). This means that the selected ON/OFF channel is deleted. Then
the radio-controlled socket returns to the teach-in mode. The total time is
29 seconds.
CR2032
Overload
EN
14