Parts Identification - Romus 96200 Mode D'emploi

V.Fitting the bulb
To fit the supplied halogen bulbs you need to loosen the screw( B )securing the hinged front cover and swing
the cover down, The bulb is attached by spring loaded holders at each end. Gently locate the bulb into position
ensuring good contact at both ends. Take care not to touch the glass of the bulb if this does occur clean the
bulb with methylated spirit. Close the hinged front cover and re-tighten the top retaining screw(B) .
The lighting direction can not be adjusted to down ward.
VI. Change the bulb
1.Before maintenance and replacement of bulb always make sure the power supply has been switched off.
2. Open the lamp cover.
3.Twist the old bulb out carefully.
4.Twist a new bulb into the socket. Make sure that new bulb fits technical data of your lamp.
5. Close the lamp cover.
WARNING: The maintaining should be done only by a qualified electrician.

Parts Identification

A : Padded Carry Handle
B : Cover Retaininfg Screw
C : Protective Grill
D : Angle Adjustment Screw Knob
E : Stand
F : Mains cable
Spare halogen lamp – Ref. 96201
This marking indicates that this product should not be disposed with other household
wastes throughout the EU. To prevent possible harm to the environment or human health
from uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse
of material resources. To return your used device, please use the return and collection
systems or contact the retailer where the product was purchased. They can take this
product for environmental safe recycling.
C
D
E
A
B
F