Alpine F#1 Status SPX-Z18T Mode D'emploi page 20

Network Jumper Setting
Type-2A: For the tweeter in this case,
pathlength from the listening position is con-
sidered to be 85cm, at approximately 15-
20° off-axis. Located at a moderate vertical
distance down from the tweeter and basi-
cally flush to the panel, the midrange is
8.5cm farther away and presents a listening
angle of about 40-50°. Due to the low door
woofer location however, the listening angle
for the woofer is close to 60° off-axis, with
its acoustic center 8cm farther relative to the
mid. For the tweeter/mid transition, a 3rd
order high-pass and semi-1st order low-pass
with increased level on the mid are engaged,
resulting in a summation point of 4kHz. Op-
timum integration between the woofer and
mid is then achieved with 4th order high-pass
and low-pass at 700Hz.
Notes:
• Highlighted tweeter level jumpers are the recommended settings for each configura-
tion, but user adjustment may be desirable.
• Transfer function simulations only illustrate the effect of the filter upon the input sig-
nal, and therefore do not represent the actual frequency response of the system.
• If separate channels of amplification are used (bi-wire or tri-wire mode), the appro-
priate signal link jumpers must be removed.
Autogood products internet store http://130.com.ua
MID HP/LP
SPX–Z18T
WF/MID
WF LP
SIGNAL LINK MID HP/LP
+
—
10
0
–10
–20
–30
–40
–50
20Hz 30Hz 100Hz 300Hz
TW HP
HP-1
HP-2
HP-3
BYPASS
MID/TW
SIGNAL LINK
+
—
1.0KHz 3.0KHz 10KHz 30KHz
TW LEVEL
17