Mustek PM 1000 AVR Schuko Guide Rapide page 3

4. Mounting Unit
The unit can be mounted to a wall surface. There are two ways to position the unit: vertically
and horizontally.
1. Use a ruler to draw a straight line in 114 mm vertically or horizontally on the wall.
2. Use a sharp nail to puncture the center of the two ends to mark the wall.
(see below chart 1 as placing the unit horizontally)
3. Mount the unit by positioning the key-hole slots over the mounting nails. (see chart 2 and
chart 3)
Chart 1 Chart 2
114 mm distance between 2 holes Mounting horizontally
5. Applications
CAUTION: The total power consumption of all equipment plugged into the voltage
regulator must not exceed its capacity*. A total load in excess of its capacity* will cause the
fuse to fault (blow).
*For the capacity of unit, please check the specifications.
The voltage regulator is designed for use with voltage sensitive equipment such as: a home
computer, monitor, inkjet printer, scanner or fax. It is also designed for use with home
electronics equipment such as television, stereos, CD players, VCRs, and DVD players, data
processing equipment, modems, typewriters, calculators, and telephone equipment.
Appliances not suitable for use with the product are items such as freezers, power tools, air
conditioners, dehumidifiers, blenders, or any device that employs an AC motor for operation.
Not for use with small fuel generators. Also excluded are life sustaining equipment.
When use the voltage regulator with an Uninterruptible Power Supply (UPS), connect the
UPS to the output of this product, then connect the product to the wall outlet.
Chart 3
Mounting vertically
5
6. Important Safety Warning (SAVE THESE INSTRUCTIONS)
To safely operate this voltage regulator, please read and follow all instructions
carefully. Read this manual thoroughly before attempting to unpack, install, or
operate. You may keep this quick guide for further reference.
CAUTION: The unit is designed only for use under the 50 Hz input frequency and pure sine
wave environment. Any other input frequency or wave form will affect the voltage range
and load capability.
CAUTION: Please DO NOT connect the unit to the environment with direct voltage or
simulated sine wave.
CAUTION! To prevent the risk of fire or electric shock, install in a temperature and
humidity controlled indoor area free of conductive contaminants. (See the specifications for
the acceptable temperature and humidity range.)
7 Specifications
Model
CAPACITY
INPUT
Voltage
Voltage Range
Frequency
OUTPUT
Voltage Regulation
Output Receptacles
INDICATOR
Power LED
AVR LED
Over-voltage LED (option)
PHYSICAL
Dimension (DxWxH)
Net Weight (kgs)
Environment
Humidity
Noise Level
PM 1000 AVR Schuko
1000VA/500W
230 VAC
184-284 VAC
50 Hz
± 10%
Schuko x 3
Green lighting
Yellow lighting
Red lighting
180 x 95 x 114 mm
1.6
0-90 % RH @ 0-40° C (non-condensing)
Less than 40 dB
6
EN