Electrical Connection - Electrolux EFG5530 Mode D'emploi

Connection in Ducting Version
When installing the ducting version,
connect the hood to the chimney using
either a flexible or rigid pipe ø 150 or
125 mm, the choice of which is left to
the installer.
To install a ø 150
• To install the dumper 10a.
• Fix the pipe in position using suffi-
cient pipe clamps (not supplied).
To install a ø 125
• To install a ø 125 mm air exhaust
connection, insert the reducer flange
9 on the dumper 10a.
• To install the Adapting ring 10b.
• Fix the pipe in position using suffi-
cient pipe clamps (not supplied).
• Remove any activated charcoal fil-
ters.
Connection in Recycling Ver-
sion
• Connect the flange to the outlet on
the shelf over the hood using a flex-
ible or rigid pipe (ø120 or 150 mm).
• To install a ø 120 mm air exhaust
connection, insert the reducer flange
9 on the hood body outlet.
• Fix the pipe in position using suffi-
cient pipe clamps (not supplied).
• Ensure that the activated charcoal
filters have been inserted.

Electrical Connection

• Connect the hood to the mains
through a two-pole switch having a
contact gap of at least 3 mm..
electrolux 40
Installation
ø 150
10a
ø 125
10b
9
10a
ø120
9 9
EN