Interphone PWB6000 Mode D'emploi page 10

Technical data
High capacity battery pack 6000mAh Li-polymer
DC input : 5.0V – 800mA
DC output : 5.0V-5.5V – 1000mA
Led indicators : 30% - 70% - 100%
PowerBank6000 weight : 200 Gr.
Use
Before using a Powerbank6000 it is necessary to fully recharge it
Powerbank6000 recharge
1.Take the cable supplied in the kit (A)
2.Insert the USB plug (B) into a USB port in your pc, or in a common
USB charger
3.Connect plug (C) with the Powerbank6000's output IN (E)
4.The three Led indicators will turn on and will be flashing depending on the
residual charge
5.Powerbank6000 will be completely charged when the three Led indictors
(30%,70%,100%) will be constantly on
6.If you disconnect the cable the 100% charge Led will turn on, this will
indicate that the PowerBank6000 is on, if you do not plug or connect anything
to the PowerBank6000, the Led and the device itself will turn automatically
off after 20 seconds.
Recharging cell phones or generic devices (MP3 player, camera, etc)
1.Make sure that the voltage of the device to be recharged is compatible with
the PowerBank6000
2.Simply connect the USB cable supplied with your phone or the device we
wish to recharge to the USB plug (D)
3.Connect the other end of the cable to the cell phone or the device we Want to
recharge
4.Press the ON/OFF button (G) to turn PowerBank6000 on
5.If you do not have the required USB cable, you can simply use the cable
supplied with the kit (A)
6.Pick the right cell phone adaptor compatible with your device (L), and plug it
in the socket on the cable (F)
7.Connect the cable like shown in 2
Verifying the recharge levels
1.Press the button ON/OFF (G) for about 4 seconds, depending on which Led
will flash, you will know the percentage of the residual charge
(30%,60%,100%)
6
EN