Assembling The Left Refrigerator Door - LG LFX28968 Serie Manuel Du Propriétaire

Assembling the Left Refrigerator
Door
Install the left refrigerator door after the right
door is installed.
1
Lower the door onto the middle hinge pin.
(2)
(3)
(5)
(6)
(7)
(8)
2
Fit the top hinge (7) over the hinge lever
latch (8) and into place.
3
Rotate the lever (6) clockwise to secure
the hinge.
4
Install the grounding screws (5) and
connect the two wire harnesses (4).
5
Push the water tube (3) located at the top
of the left door into the hole beside the left
hinge on the top of the cabinet until it exits
through the back.
6
Insert the water supply tube (3) into the
connector until you see only one scale
mark. Fully insert the tub cover (15 mm).
7
Hook the tabs on the left side of the hinge
cover (1) under the edge of the top hinge (7)
and position the cover in place.
8
Insert and tighten the cover screw (1).
(1)
(4)
9
Insert the water supply tube at least 5/8 in.
(15 mm) into the connector.
10
Hook the tab on the door switch side
of the cover under the edge of the wire
opening in the cabinet top.
11
Position the cover into place. Insert and
tighten the cover screw.
NOTE
Collet
Tube
Insert Line
Clip
1) Gently press the Collet and insert the
tube until only one line shows on the
tube.
(Incorrect)
2) Pull the tube to make sure that the
tube is tightly fastened and then insert
the clip.
INSTALLATION 15
(Correct)