Care Instructions; Your Product; Precautions For Use - Hesperide LAMBADA 165267 Mode D'emploi

CARE INSTRUCTIONS

1/ Your product

Properties
Aluminium is a light, resistant material that doesn't rust.
Ceramic is a terra cotta-based material heated at a high temperature. Ceramic has a great resistance
to knocks, blows and scratches. It also has a great resistance to cold and is easy to clean.
Manufacturing and assembly
The manufacturing then assembly of this product requires leaving clearance between the different
parts.
It is therefore normal to observe gaps/slack that may reach several millimetres between the different
assembled elements (between two slats, between boards...).
This tolerance necessary for the correct realisation of your product can be behind little geometric
differences.
This does not lead to any loss of function of your product.
Irregular appearance
Each product is manufactured and assembled industrially from parts whose surface treatment is
carried out individually, before assembly. These metallic elements cannot be free from appearance
irregularities coming both from the surface treatment process and assembly operations. The final
appearance of the product is therefore directly linked to these possible irregularities.

2/ Precautions for use

Do not put hot objects on the table itself, they will leave permanent marks on it (discoloration,
deformation, cracks...). Always use table mats.
Do not use a plastic tablecloth on the table. Exposed to UV and heat, it would melt and act as a
decal, especially on steel, aluminum and glass. This would result in irreparable deterioration of the
tray in the form of white streaks. Instead, use a fabric tablecloth.
3/ Maintenance and ageing, siding
It is normal to note natural wear and tear of the product over time and with use, in the form of an
alteration of the colours and the state of the surface, the mechanical functions and tightening of the
screwed elements.
Exposure to UV rays
Over time, you can see a discoloration of the materials exposed to UV rays (textiles, paint, plastics), a
phenomenon also due to the rays of the sun as well as those of the moon. This evolution of colours
exposed to external elements is normal and concerns in particular bright colours.
Tightening
The assembly parts of your product become loose over time. Think of tightening them regularly.
Everyday maintenance
Your product is subject to external elements, it must therefore be regularly cleaned.
Remove stains immediately.
Clean with a damp cloth soaked in warm soapy water (or hot water for more marked dirt) or a
specific, adapted product.
Rinse thoroughly.
Finish with a clean, dry cloth.