Maintenance - Go CS1600 Manuel De L'opérateur

◾
When bucking on a slope, always stand
on the uphill side of the log (Fig. 22).
◾
To maintain complete control when
cutting through, release the cutting
pressure near the end of the cut
without relaxing the grip on the
chain saw handles. Don't allow the
chain to contact the ground. After
completing the cut, wait for the saw
chain to stop before you move the
chain saw. Always stop the motor
before moving from tree to tree.

MAINTENANCE

WARNING:
parts may create a hazard or cause product damage.
WARNING:
power tool operation or when blowing dust. If the operation is dusty, also wear a dust mask.
WARNING:
chain saw before inspecting, cleaning, or performing maintenance. A battery operated tool
with the battery pack inserted is always on and can start accidently.
WARNING:
WARNING:
products, penetrating oils, etc., come in contact with plastic parts. Chemicals can
damage, weaken, or destroy plastic, which may result in serious personal injury.
CLEANING
◾
After each use, clean debris from the chain and guide bar with a soft brush. Wipe
the chain saw surface with a clean cloth moistened with a mild soap solution.
◾
Remove the side cover, and then use a soft brush to remove debris from the guide
bar, saw chain, sprocket and side cover.
◾
Always clean out wood chips, saw dust, and dirt from the guide bar groove when
replacing the saw chain.
56V LITHIUM-ION CORDLESS CHAIN SAW — CS1600/CS1600-FC
When servicing, use only identical replacement parts. Use of any other
Always wear safety goggles or safety glasses with side shields during
To avoid serious personal injury, remove the battery pack from the
When cleaning the chain saw, DO NOT immerse in water or other liquids.
Do not at any time let brake fluids, gasoline, petroleum-based
22
35