Preparation; Tools Required; Site Selection - komodo SP5735 Manuel D'utilisateur

Preparation

IMPORTANT INFORMATION
1. Before you begin, locate the instructions and hardware. Be sure you have all of the parts and can identify
them.
2. To avoid scratching the finish, assemble the product on a soft, non-abrasive surface such as carpet or
cardboard.
3. Assembly of this product may require more than one person.
4. Select a location that is not susceptible to moisture, dust and is away from high traffic locations and things
that many catch fire or block openings such as drapes, pillows, furniture etc.
5. It is strongly recommended that the screws be screwed into the wall studs where possible. If the wall studs
cannot be used, wall anchors must be used.
CAUTION: Enclosed wall anchors (BB) only can be use on the concrete wall.
6. For the best effect install the fireplace out of direct sunlight and away from overhead lighting.

Tools Required

Philips Screwdriver

Site Selection

Select a location that is not susceptible to moisture, dust and is away from high traffic locations and things that many
catch fire or block openings such as drapes, pillows, furniture etc.
Min. 2 inch
WARNING: This appliance is hot when in use. To avoid
burns, DO NOT let bare skin touch hot surfaces. Keep
combustible material, such as furniture, pillows, bedding,
papers, clothes and curtains, at least 3 feet from the front of
the heater and keep them away from the side and rear.
Min.
Minimum clearance of the fireplace to the adjacent wall
2 inch
Sides
Floor
Top
Min. 6 inch Back
Hand Drill
-------------------------------
-------------------------------
-------------------------------
-------------------------------
Hex Key
2 inch / 5 cm
6 inch / 15 cm
6 inch / 15 cm
0 inch / 0 cm
5