Sicce SPACE EKO+100 Mode D'emploi page 10

c. Replace the impeller and check that it rotates freely on its shaft.
d. Replace the filter cover after checking that the O-ring is positioned correctly (fig. 5), close the 4 clamps, and then
connect the hosetail fitting (fig. 8/12).
When inserting the handle of the hosetail fitting the water flow fills the filter automatically.
The SPACE EKO+ is now ready for use again: plug it in and make sure that it is working correctly.
ATTENTION! Calcium deposits and the natural wearing of the components might cause an increase of the pump's
noise. In this case, we recommend you to replace the rotor.
INSTALLATION OF THE FILTER IN A TURTLE TANK
When selecting the filter for a turtle tank, choose the model that can manage twice the water volume in the tank, due
to the high amount of waste produced by turtles.
WARNING : when initially installing the filter and after cleaning it, be sure to increase the water level in the tank or
partially fill the filter canister to avoid the water level in the tank dropping too low during the priming operation. The
minimum water level in the tank must be around 8-10 cm.
WARNING : position the intake grid in the area of the tank with maximum water depth so it is always submersed and
it doesn't suck air. Both the inlet and outlet tubes can be shortened according to the height of the tank.
WARRANTY
This product, apart from the impeller, is guaranteed against defects of materials and workmanship for a period of 3
years from the date of purchase. The guarantee certificate must be filled in by the dealer and must accompany the
pump if it is returned for repair, along with the receipt or other proof of purchase. The guarantee covers replacement
of the defective parts. In case of improper use, tampering or negligence by the buyer or user, the guarantee is void
and expires immediately. The guarantee is also void if no receipt or other proof of purchase is available. The cost of
shipping the pump to and from the factory, or the place of repair, will be borne by the buyer.
INSTRUCTIONS FOR THE CORRECT DISCHARGE OF THE PRODUCT ACCORDING TO EU DIRECTIVE
2002/96/EC
When used or broken, the product does not have to be discharged with the other waste. It can be delivered
to the specific electric waste collection centres or to dealers who give this service. Discharging electric tools
separately avoids negative consequences for the environment and health and allows the materials to be
recycled so to have a great saving of energy and resources.