Maintenance Tips; Warranty Information - General IRTC50 Mode D'emploi

MAINTENANCE TIPS

Clean the lens often—but never use a solvent. Abrupt
temperature changes will cause condensation and possible vapor penetration.
Clean after the vapor evaporates. Blow off loose particles with clean, com-
pressed air. Gently brush remaining debris away with a lens hair brush.
Carefully wipe the surface with a moist cotton swab.
Avoid water, moisture and corrosive gas or liquids. The housing can be cleaned
with a wet sponge.
Remove the battery when storing this product for an extended period of time.
Do not drop or disassemble the instrument or immerse it in water.

WARRANTY INFORMATION

The IRTC50 IRT InfraRed Thermal Scanner with Laser Star Burst Targeting
System from General Tools & Instruments (General ® ) is warranted to the original
purchaser to be free from defects in material and workmanship for a period of
1 year. Subject to certain restrictions, General will repair or replace this instru-
ment, if after examination, it is determined by General to be defective in mate-
rial or workmanship.
This warranty does not apply to damages that General determines to be from
an attempted repair by non-authorized personnel or misuse, alterations, normal
wear and tear or accidental damage. The defective unit must be returned
to General Tools & Instruments or a General authorized service center, freight
prepaid and insured.
Acceptance of the exclusive repair and replacement remedies described herein
is a condition of the contract for purchase of this product. In no event shall
General be liable for any incidental, special, consequential or punitive damages,
or any cost, attorneys fees, expenses, losses alleged to be as a consequence of
any damage due to failure of, or defect in any product including, but not limited
to, any claims for loss of profits.
1