Before First Use - Carrera 655 Mode D'emploi

05. BEFORE FIRST USE

Before first use
1. Unpack the appliance and remove all packaging material.
2. Clean the glass jar carefully (→"Cleaning and Care").
3. Make sure that all parts – especially the connections on the underside of the
glass jar – are completely dry before assembling the appliance.
4. After assembly, fill the glass jar with 0.5 l of water and heat it for 3 minutes.
Smoke or light odour may be generated, which is perfectly normal at this
stage.
Assembly
1. Place the lid on the glass jar and fix it by pressing it down.
2. Insert the dosing cap into the refill opening of the lid.
CAUTION: Always make sure that the lid and dosing cap are properly
fixed before starting the appliance.
Hot steam may escape through the dosing cap whilst the appliance is
● ●
heating. This is normal, which is why the dosing cap must be handled
with care.
Be careful when filling hot liquids into the blender since these may
● ●
spurt out due to steam suddenly escaping from the appliance.
Do not remove the lid whilst the water is boiling.
● ●
3. Considering the locking mechanism, place the glass jar on the motor block.
CAUTION! Risk of material damage
The glass jar must be carefully placed on the motor block.
In the event that it has not been inserted properly, there is a danger
that the connecting elements for the locking mechanism get damaged
and that the appliance is no longer operable.
Disassembly
1. Disconnect the mains plug to switch off the appliance.
2. Carefully remove the glass jar, without turning it, from the motor block.
32 GB