Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Tools required for assembly: Adjustable wrench
Assembly Instructions
A. Insert threaded end of Wheel Hook Assembly through one of the holes in the Arm Support tubes.
Secure the Wheel Hook Assembly using the supplied T Knobs by tightening them onto the threaded
portion of the Wheel Hook Assembly.
B. Line up bottom hole of wing assembly with square hole of the shank assembly. Insert carriage bolt and
thread on the lock nut. Tighten with wrench. Repeat for other wing assemblies.
C. Depending on the desired setting, insert bail pin and repeat for other side.
D. Insert front shank assembly inside rear shank assembly. Install T‐Handle and tighten.
E. Attach Safety cable with supplied clips to the cable brackets on the shank assemblies.
Vehicle Mounting Instructions
A. Simply slide the shank into the receiver and secure with pin and clip.
B. To access the rear of the vehicle without bikes loaded, remove bail pins and tilt wing assemblies to the
ground.
Instructions
Storage
In Use
Rear of Vehicle
Access
Publicité
Table des Matières
