Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
4
ELECTRICAL
A. From Above, make electrical
connections.
1. Connect power to luminaire where Black is Line,
White is Neutral and Green is Ground. Replace the
electrical access plate with gasket seated against
fi xture and fasten with provided hardware. Use
liquid tight fi ttings (not supplied) to form a
weather tight seal to luminaire. (See Fig.4)
2. If ordered with accessory junction box, mount the
junction box to the top of the fi xture using provided
hardware, connect lead wires same as above.
Replace Junction box cover with all provided
gaskets. Use liquid tight fi ttings (not supplied) to
form a weather tight seal to luminaire.
FIGURE 4
Notes:
• Install this product in accordance with applicable
local, state, and national electrical codes by a
licensed person familiar with the construction
and operation of the product and hazards involved.
• Ground the luminaire to protect against shock
hazards and to assure proper operation.
• Turn off electrical power while installing the fi xture.
• If the supply cord is damaged, it must be replaced
by the manufacturer or its service agent or a similar
qualifi ed person in order to avoid a hazard.
• Ensure that the structure on which the fi xture is
installed can support at least a load of 20 pounds
to avoid risk of fi xture falling.
• Recommended fi xture installation height is 16 ft
or higher.
Hole For Liquid
Tight Fittings
Electrical
Access Plate
5
PRODUCT DIMENSIONS
Recessed Mount
(Dimensions in Inches)
Bottom View:
15.9
Side View:
13.4
7.1
Publicité
Table des Matières
