Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Operating Instructions
•
Remove all package material (including anti-vibration object of the lamp) and check the
appliance, supply cord and the plug for signs of damage.
•
Pay attention to the mounting place and all mounting material (dowels, screws). Ensure
they are suitable and stable enough for mounting and lastingly holding of the appliance.
•
Before mounting, the minimum safe mounting distances and tilt angles shown in the
figures must be strictly followed.
•
The distance between the bottom edge of the appliance and the floor must be at least 1.8
M. See figure 2.
•
There must be a distance of at least 0.25 M between the appliance and the ceilings, roofs
or other covers. See figure 2.
•
There must be a distance of at least 0.5 M at each side between the appliance and walls
or the like. See figure 2.
•
Recommended degree to mounting surface is 45°. See figure 3.
•
The rotation angle is 60°. See figure 5.
•
Pay attention that, the installation of the appliance must not add excessive wind load.
•
Fix the mounting bracket to the ceiling l first. Ensure that the place to be installed is
secure and firm. Or connect the appliance to the stand.
•
Adjust the desired angle of radiation and fest screw all screws. Check regularly the
screw's connection. Mechanical bearing pressure and oscillation due to wind or rain
could lead to lose.
•
Plug in the power source and operate the remote control. Then observe, whether during
the first 10-15 minutes the appliance works trouble-free.
•
If you do not use, please remove battery socket
8
EN
Publicité
Table des Matières
