Before Use - SFA OMEGA 47050C Manuel Des Consignes D'utilisation Et Des Pièces

PREPARATION
47053 Assembly (refer to Fig. 2 & 4)
1. Attach 3 1/2" caster (1) to left and right main frame (2 & 3) with bolts & washers (4).
2. Attach 5" caster (5) to rear support (6), with bolts, washers & nuts (7).
3. Insert left main frame (2) into right main frame (3).
4. Attach upright (8) and rear support (6) into the main frame assembly (2 & 3) with two bolts & nuts (9) and four
bolts, washers & nuts (10).
5. Attach support straps (11) to the mouting ears of upright and main frame with bolts, washers and nuts (12).
6. Attach hydraulic unit (13) onto the upright assembly (8).
7. Insert load leveler handle (14) to rear support (6) with pin and cotter pin (15 & 16).
8. Attach the chain (17) onto upright assembly.
Size of Hardware Kits
4 bolt M8x16
lock washer M8
7 bolt M8x16
lock washer M8
nut M8
9 bolt M12x100
nut M12
10 bolt M14x110
washer M14
nut M14
12 bolt M8x34
lock washer M8
nut M8

BEFORE USE

1. Verify that the product and the application are compatible, if in doubt call Omega tech. service (888) 332-6419.
2. Before using this product, read the operator's manual completely and familiarize yourself thoroughly with the
product, its components and recognize the potential hazards associated with its use.
3. To familiarize yourself with basic operation; position the hydraulic unit upright as shown in Fig. 1 & 2, engage the
release valve with the slotted portion of the provided handle, then turn the release valve:
a. Clockwise until firm resistance is felt to further turning. This is the 'CLOSED' release valve position used to
raise the load.
b. Counter-clockwise, but no more than 1 turn from the closed position. This is the 'OPEN' release valve position
used to lower the load.
4. With power unit fully lowered and release valve closed, pump the operating handle. If power unit responds
immediately, dolly is ready for use. If power unit does not respond, follow the Bleeding/Venting instructions.
5. Place the hydraulic unit to the wheel dolly as shown in Fig. 1 & 2. Position the hydraulic unit such that the saddle
mates with the provided indentation.
6. Check to ensure that wheel dolly rolls freely, that the pump and release valve operate smoothly. Raise and lower
the unloaded wheel dolly throughout the lifting range before putting into service. Replace worn or damaged parts
and assemblies with
Bleeding / Venting Trapped Air
With the release valve in the OPEN position (3b.) and with saddle fully lowered, locate and remove the oil filler
plug. Pump 6 to 8 full strokes. This will help release any pressurized air which may be trapped within the reservoir.
Reinstall the oil filler plug.
Qty
8
8
4
4
4
3
2
2
4
4
4
4
4
4
Figure 4 - Assembly Illustration for Model 47053
Factory Authorized Replacement Parts only.
8
10
1
4
4
17
13
14
16
15
9
5
6
7
11
12
2