Ground Connection - Tripp-Lite SmartRack SRCABLELADDER18 Manuel Du Propriétaire

3. Installation
After inserting the clevis pins, insert a cotter pin
6
hole at the end of each clevis pin. (The straight section of the
cotter pin goes through the hole.)

3.6 Ground Connection

1 After installing the SRCABLELADDER18 accessory, determine
where to place ground brackets by noting the distance between
one end of the ladder and the grounding post
the nearest SRCABLETRAY accessory.
Place a ground bracket
2 B
SRCABLELADDER18 accessory's leg and use a hex-head bolt
to secure it.
Use the included hex nuts and lock washers
3
end of the included ground cable
the corner of the nearest SRCABLETRAY accessory and connect
the other end to the grounding post
attached to the SRCABLELADDER18 accessory. Repeat steps
1 to 3 for the other end of the SRCABLELADDER18 accessory.
through the
G
A at the corner of
near the end of the
to connect one
G
H to a grounding post
J of the ground bracket
6
1
C
C
2
I at
3
7
G
A
B
G
I
H
G
J