Briggs & Stratton 1696156 Manuel D'utilisation page 10

Operation
Before Operating the Snowthrower
WARNING
Read the operator's manual before operating the
machine. This machine can be dangerous if used
carelessly.
• Never operate the snowthrower without all guards,
covers, and shields in place.
• Stop the engine whenever leaving the operating
position.
• Remove the key before unclogging the impeller
housing or discharge chute, and before making repairs
or adjustments.
• When leaving the machine, remove the key.
• To reduce the risk of fire, keep the machine clean and
free from spilled fuel, oil, and debris.
• On electric start models, disconnect the extension cord
before operating.
• Be sure to check the engine oil level before starting
the engine. See the engine operator's manual for oil
recommendations.
Operating the Snowthrower
DANGER
Amputation hazard
The discharge chute contains a rotating impeller to
throw snow. Fingers can quickly become caught in
the impeller. Never clear or unclog the discharge
chute with your hands. Always use a clean-out tool.
Failure to observe these safety instructions will
result in traumatic amputation or severe laceration.
Hand contact with the rotating impeller inside the
discharge chute is the most common cause of injury
associated with snowthrowers. Never use your hands to
clean out the discharge chute.
To safely clear a clogged discharge chute, follow
these instructions:
1. Shut OFF the engine.
2. Wait 10 seconds to be sure the impeller blades have
stopped rotating.
3. Always use a clean-out tool, not your hands.
10
DANGER
Toxic fume hazard
Engines give off carbon monoxide, an odorless,
colorless, poison gas.
Breathing carbon monoxide can cause nausea,
fainting, or death.
• Start and run the engine outdoors.
• Do not run the engine in an enclosed area, even if
doors and windows are open.
WARNING
Thrown objects hazard
This machine is capable of throwing objects that could
injure bystanders, or cause damage to buildings.
Be sure the operating area is clear of bystanders. Never
direct the discharge toward anyone, or toward buildings
or cars.
1. Start the engine. Please refer to the engine operator's
manual for engine information.
2. Rotate the chute rotation crank (C or D, Figure 3) or
use the chute rotation switch (E) to set the direction of
the discharge chute.
3. Models with manual defector adjustment: Loosen
the wingnut securing the chute deflector (I, Figure
3). Raise the deflector to throw snow further. Set the
defector to the desired position and tighten the wingnut.
Models with in-dash deflector control lever: Use
the deflector control lever (H, Figure 3) to move the
deflector up or down. Raise the deflector to throw snow
further.
Models with electric deflector control: Use the
deflector control switch (J, Figure 3) to move the
deflector up or down. Raise the deflector to throw snow
further.
4. Use the speed select lever (B, Figure 3) to select the
forward or reverse drive speed. Use lower speeds when
clearing wet, heavy snow. Use higher speeds for light
snow or transporting.
NOTE: Always set engine speed to FAST (full throttle).
5. Fully press the auger control lever (A, Figure 3) to
engage the auger. Release the lever to stop the auger.
6. Fully press and hold the traction control lever / Free
Hand control (F/G, Figure 3) to engage the traction
drive and begin moving the snowthrower. To stop,
release the lever.
NOTE: Always release the traction control lever before
changing speeds.