Indoor Unit Installation Drawings - Daikin FTX09NMVJU Manuel D'installation

Indoor Unit Installation Drawings

A Mounting plate
B
Mounting plate
fixing screw
3/16" × 1" (M4 × 25mm)
Front panel
1-15/16" (50mm) or more
from walls (on both sides)
Air filters
C
Titanium apatite photocatalytic
air-purifying filter (2)
(FTXN or FTKN models: Sold separately.)
09/12 class
Titanium apatite photocatalytic
air-purifying filter
18/24 class
Titanium apatite
Filter frame
photocatalytic
air-purifying filter
Tab
Claw
■
English
The A mounting plate
should be installed on a
wall which can support the
weight of the indoor unit.
1-3/16" (30mm) or more from ceiling
Screws
3/16" × 5/8" (M4 × 16mm)*
*The 18 and 24-class models have 3 screws.
The service lid is removable.
Opening method
1) Remove the service lid screw.
2) Pull out the service lid horizontally in
the direction of the arrow.
3) Pull down.
D Wireless remote
controller
Air filter
How to attach the indoor unit
Hook the hooks of the bottom frame
to the A mounting plate.
If the hooks are difficult to hook,
remove the front grille.
How to remove the indoor unit
Push up the marked area (at the
lower part of the front grille) to
release the hooks. If it is difficult to
Front grille
release, remove the front grille.
Caulk
pipe hole
gap
with putty.
Appearance of
indoor units may
differ from some
models.
(This is a 09/12
class illustration)
Service lid
Fixing screw for remote
F
controller holder
1/8" × 13/16" (M3 × 20mm)
A
Mounting
plate
Hook
Bottom frame
Mark (rear side)
Cut thermal insulation
pipe to an appropriate
length and wrap it with
tape, making sure that no
gap is left in the insulation
pipe's cut line.
Wrap the insulation pipe with
the finishing tape from bottom
to top.
Before screwing the
E remote controller
holder to the wall, make
sure that control signals
are properly received by
indoor unit.
E
Remote
controller holder
4