PCM GSA-306-L-522 Mode D'emploi page 2

English
1. To fix the tool holder to the machine,
introduce the shank and use the pin for
the positioning.
Then tighten the 2 Ball-ended thrust
screws supplied. (Important, watch
that the screws have the same
strength of tightening).
2. Use the pin plates to change the angle of
the cutter head.
Zone industrielle C
Rte du Grammont 101
CH-1844 Villeneuve
Mode d'emploi
Operating instructions
Betriebsanleitung
Istruzioni per l'uso
GSA-306-L-522
3. Adjust the offsets of 2 positions.
4. During the mounting or the dismounting of
5. The tool shank diameter should never
NOTE :
positions. Use the supplied protection plug.
PCM WILLEN SA
SWISS MADE
Copyright © PCM Willen SA.
Garant:
BT
Validation: 29.11.2021
your cutting tools, block the broach on
flats planned for that purpose, using an
adapted wrench.
have a difference of more than 0.4 mm
compared to the clamping diameter of
collet
Example: clamping diameter 9.5 mm =>
Shank diameter 9.1 mm minimum.
Never use the tool holder with empty
Tél ++41 21 967 33 66
Fax ++41 21 960 38 95
http://www.pcm.ch
email:
Document:
GSA-306-L-522
Mode d'emploi.docx
Page: 2 de 4
office@pcm.ch