Kiva Prima + Manuel D'utilisation page 37

7. REPLACEMENT OF THE ROLLER
WARNING: Be sure to wear work gloves.
Caution: use only original scarifier/aerator shafts approved by the manufacturer.
The equipment can be assembled with the scarifying roller or the aerator roller.
Only replace the roller with an original roller, as this will ensure top performance and safety under all
conditions.
To change the scarifying roller or the aerator roller, which is available as an option, proceed as follows.
5. Switch off the engine and leave to cool down.
6. Remove spark-plug terminal.
7. Remove the grass catcher.
8. Raise the unit slightly at the front.
Note: Do not raise too high, fuel may run out of the tank, if required, drain fuel before changing the roller.
Remove the roller
3. Remove the four screws. (Fig.11B)
4. Lift the roller and pull out in the direction of the arrow. (Fig.11C)
Fig.11A
Assemble the roller
1. Slide the new roller in the direction of the arrow, insert the shaft into the hexagonal socket and press the
other side into the holder (Fig.11C/ Fig.11D/ Fig.11E).
2. Refasten the roller with the two screws.
3. Check that the roller is seated correctly.
4. Assemble aerator shaft the same as scarifier shaft. (Fig.11F/ Fig.11G/ Fig.11H).
Fig.11C
Fig.11B
Fig.11D
15 - EN
Fig.11E