Dennerle CarboNIGHT M400 Notice D'emploi page 28

7.9 How the CO2 flipper works
The flipper is a modern, highly effective CO2 diffuser. It ensures that the valuable CO2 fertilizer is used to the best possible
effect.
While the CO2 bubbles slowly rise inside the flipper, the CO2 dissolves in the aquarium water. At the same time, other gases
naturally dissolved in the aquarium water penetrate the CO2 bubbles. These so-called waste gases are the reason why the
bubbles become smaller towards the top, but do not dissolve completely.
The waste gases are significantly lighter than the relatively heavy CO2, which causes them to collect in the CO2 collection tank
at the top. Here they are regularly removed by the special waste gas vent.
The running-in period of the flipper is about 2 days. Initially the individual CO2 bubbles combine to form larger bubbles.
As soon as a biological surface of micro-organisms has formed, the bubbles run through to the collection tank.
8 What to do if... – Troubleshooting
Errors
A quiet hissing can be heard at the
screw connection of the pressure
reducer and CO2 bottle
No more bubbles on the CO2 diffuser
CO2 bubbles getting stuck in the flipper Flipper is still in the running-in phase
Gas escapes from the side of the
collection tank
9 Add-on
Fully automatic measurement and regulation:
The Dennerle pH controller Evolution measures the pH value in the aquarium on an ongoing basis and regulates the ad-
dition of CO2 precisely and fully automatically via the attached CO2 magnet valve (pressure reducer CarboNIGHT).
28
Cause
Pressure reducer is screwed on at an
angle or not tight enough
Seal in pressure reducer is dirty or
defective
Seal in adapter is dirty or defective
Magnet valve closed
CO2 bottle empty
Operating pressure too low
Hose connection leaking
Needle valve closed
Obstacles on the connector (snails,
algae)
Bottom suction cup not tight against
glass
Flipper not mounted vertically
Waste gas vent (slit) dirty
Solution
Unscrew the pressure reducer and
screw it back on straight.
Clean the sealing surfaces.
Replace the seal if necessary (Dennerle
After-Sales Service).
Clean the sealing surfaces.
Replace the seal if necessary.
Open the magnet valve.
Replace the CO2 bottle.
Increase the operating pressure.
Check the hose connections and
replace if necessary.
Open the needle valve.
Wait for the end of the running-in
phase.
Clean the area.
Clean the glass, press the suction cup
firmly in place
Mount the flipper vertically.
Clean the area.