Table des Matières
Publicité
PIÈCES ET COMPOSANTES
1.
Poignée supérieure
2.
Tubes de rallonge
(x2)
3.
Poignée inférieure du tube de rallonge
4.
Poignée inférieure
(
expédié à l'intérieur de la coupelle à poussière)
5.
Écrou et boulon captifs
(sur le pivot de la poignée inférieure)
6.
Témoin de chargement
7.
Bouton d'alimentation On/Off
8.
Adaptateur de chargement : N'utilisez que
le
modèle TechWorld AD-0815-U8,
7,5 volts-150mA
(expédié à l'intérieur de la coupelle à poussière)
9.
Coupelle à poussière
10. Couvercle de la brosse transparent
11. Brosse rotative
12. Électrobrosse balayeuse
*Les illustrations peuvent différer du produit lui-même.
REMARQUE:
Modèles de balayeuse sans fil expédiés avec des piles
non chargées. L'appareil doit être chargé pendant 20
heures avant la première utilisation. N'utilisez que les
piles de rechange X8905.
18
OPERATING INSTRUCTIONS
CARE AND MAINTENANCE
To improve the performance and life of your unit, we recommend you do the
following:
1.
Once a month clean the unit with a dry cloth, including the chamber which the dust
container fits into. Remove any hair, fiber or other materials that may have built up
in the chamber, on the rotating brush.
2.
Don't use abrasive materials to clean the sweeper. Do not immerse the unit in
water.
3.
Do not pick up liquids or use on wet floors.
4.
Do not use on concrete, tar or similar rough surfaces.
5.
Don't pick up pieces of string or fabrics with the sweeper.
6.
Do not clean tasseled or frayed carpets with the sweeper.
STORING THE CORDLESS SWEEPER
Your cordless sweeper may be stored by using the slot on the back of the upper handle
and hanging it from a screw secured to a wall or other vertical surface. Use a #6 flat or
pan head screw with the appropriate hardware for the surface that the sweeper will be
mounted on, (i.e. gyproc). Allow the screw head to extend a approximately 3/16" from
the mounting surface. Always empty your sweeper before hanging up for storage.
TROUBLESHOOTING GUIDE
PROBLEM
POSSIBLE REASON
1.
Batteries discharged.
2.
No power in electrical
SWEEPER WILL
outlet supplying charging
NOT OPERATE
adapter.
3.
Unit needs servicing.
4.
Battery misplaced.
SWEEPER WILL
1.
Dust container is full.
NOT PICK-UP
2.
Unit needs recharging.
DUST ESCAPING
1.
Dust container is full.
FROM SWEEPER
ROTATING BRUSH
1.
Unit clogged.
2.
Dust container is full.
WILL NOT PICK UP
1.
Electrical outlet not
working.
2.
Charging Adapter not
SWEEPER WILL
working.
NOT CHARGE
3.
Batteries no longer
functioning.
4.
Unit left in "On" position.
POSSIBLE SOLUTION
1.
Charge unit.
2.
Check fuse or breaker.
Replace fuse/reset breaker.
3.
Call Customer Service.
4.
Match "+" on battery to
compartment "+".
1.
Empty dust container.
2.
Charge unit.
1.
Empty dust container.
1.
Check for excessive material
on brush or in bottom of
sweeper. Remove obstruction
from brushes and/or sweeper.
2.
Empty and clean dust
container.
1.
Check to ensure outlet is
working properly. (Easily
checked by plugging in
another appliance.
2.
Replace charging adapter.
3.
See battery disposal pg. 5.
4.
Press switch to "Off".
7
Publicité
Table des Matières
