MYDLINK DCS-2802KT-EU Guide De Démarrage Rapide page 11

Camera Mounting Instructions
Threaded Mount
Step 1:
Place the mount at the desired location, assuring
that it is at least 20cm from the ceiling. Use a pencil
to mark the holes.
Step 2:
Using a 6 mm drill bit, drill two 25 mm deep holes
over the pencil marks. For a plaster, drywall, or
concrete wall, insert the plastic anchors to support
the screws first.
Step 3:
Place the mount over the holes that are in the wall.
Make sure to align the mount holes with the holes
in the wall. Use the supplied screws to attach the
mount to the surface of the wall.
Step 4:
Rotate the wing nut counterclockwise with your
fingers to slightly loosen it. Then move the bracket
to the approximate desired position.
Step 5:
Screw the camera onto the mounting screw by
tightening the plastic finger nut.
Step 6:
Adjust the angle of the arm on the mounting bracket
as required. Tighten the wing nut to lock the
camera's position into place.
DCS-2802KT-EU
1
2
3
4
5
6
11