Electrolux EFD90567OX Manuel D'utilisation page 8

8 www.electrolux.com
5. CONTROLS
Warning!When using or handling the
hood, do not leave hands within the
range of action of the suction panel
(pull-out drawer).
A
A. Panel closing button / OFF
This button allows to close the panel
completely or to stop the truck at an
intermediate position between 18 and
20cm from the hob.
The hood turns off automatically when
the distance of the panel from the hob,
closing again, becomes lower than
18cm.
B. Extraction panel up ON/Speed 1
This serves to bring the extraction panel
up to a maximum height of 30 cm and
to automatically set the first extraction
speed when the panel reaches a height
of 18 cm. Pressing the button when
this height is reached makes it possible
to place the extraction panel in the
required intermediate positions, up to
a maximum of 30 cm, while leaving
the extraction speed of the motor
unchanged.
C. Speed 2 switch
D. Speed 3 switch
E. Speed 4 switch
N.B.: when the Timer is activated at suction
speed 4 (power), the hood could switch
to speed 3 before going off, since
speed 4 already has a preset timing
when the speed is reduced.
F. 10-minute timer
This is used to switch off the extraction
system automatically as well as to close
the extraction panel 10 minutes after it
has been enabled.
Note: suction speed 4 (power) is timed
for 6 minutes, after which the hood will
automatically switch to suction speed 3
(power).
B C D
Use the high suction speed in cases
of concentrated kitchen vapours. It is
recommended that the cooker hood suction
is switched on for 5 minutes prior to cooking
and to leave in operation during cooking
and for another 15 minutes approximately
after terminating cooking.
Hood Calibration
After the hood has been installed, the
aspiration panel must be calibrated.
This operation is necessary to regulate the
power exstraction of the aspiration panel.
E F
Pushing the ON/1 "B" the aspiration panel
rises. After it has reached a height of 18 cm
from the cooktop, press OFF "A", to stop the
extraction then the Timer "F" and after sec.
the OFF button "A".
The hood will carry out the calibration of
its aspiration panel rising and retracting for
some centimeters.
During this phase, the buttons on the
pushbutton control panel blink.
Anti-pinch safety:
if an obstacle obstructs the closure of the
Downdraft, the closure is stopped and the
trolley goes up.