Installation; Installing The Mounting Brackets; Installing The Product - Glacier bay 20118-0001 Guide D'utilisation Et D'entretien

Installation

1
Marking the mounting location
□
Remove the set screw (DD) from the base of the
product post(s).
□
Place the product in the desired mounting
location, using a level to position it accordingly,
and use a pencil to lightly mark the outline of the
post(s).
□
Center the mounting bracket (BB) within the
marked post location(s), and mark where the
screw holes will be drilled.
□
Repeat this step as needed for each bath
accessory.
NOTE: The included template (EE) may be used to mark the
mounting locations for the towel bar: A and B for the
18 in. towel bar / A and C for the 21 in. towel bar / A and D for
the 24 in. towel bar.
3

Installing the product

□
Place the post over the mounting bracket (BB)
and secure it with the set screw (DD), as shown.
□
Repeat this step for the remaining post.
NOTE: Ensure the towel bar is inserted prior to securing
the second post to the mounting bracket (BB).
DD
BB
2

Installing the mounting brackets

□
Drill 1/4 in. holes in the previously marked
locations.
□
Push the plastic anchors (CC) flush into the dry wall.
□
Fasten the mounting bracket (BB) to the wall with
the wood screws (AA).
□
Repeat this step as needed for each bath
accessory.
NOTE: When mounting the products to a wood wall, fasten
the mounting brackets (BB) to the wall using the wood
screws (AA). There will be no need for drilling or plastic
anchors (CC).
5
l P a e e s o c t n c a t 1-855-HD-GLACIER
CC
AA
BB
BB AA
BB
DD
H O M D E P E
f r o u f t r e h a r s s s i a t
O . T CA
c n . e