Operation; Battery Installation - Dranetz-BMI PRO-flex ACP3000 4/24 Notice D'utilisation

______________________________________________________________
4.

OPERATION

4.1

BATTERY INSTALLATION

Never replace batteries with flexible measuring head
installed on conductor to be tested or output connected to a
display device.
Never operate the unit without the battery cover fitted.
The ACP3000_4 and ACP6000_4 require two AA MN1500 LR6
alkaline batteries for operation.
accessed from the rear of the electronics enclosure.
Battery status is indicated by an orange LED on the front of the
integrator module. This LED will flash one time when the unit is
switched ON. The length of time the LED is lit will increase as
battery life decreases. Continuous lighting of LED indicates low
battery and requires batteries to be replaced.
Should you suspect a depleted battery or the low battery LED
blinking, proceed as follows.
1. Turn "OFF" all power to the unit and measurement circuits.
2. Set the probe selector switch to the "OFF" position.
3. Remove the flexible current probe from around the conductor
of your measurement circuit. Disconnect the output from the
display unit.
4. Rotate the battery lock screw (1/4 turn) until it aligns with the
unlock symbol. The battery cover can now be removed.
5. Install the replacement batteries into the battery holder.
6. Replace the battery cover and turn the battery lock until it
aligns with the lock symbol.
_______________________________________________________________
The battery compartment is
8